Home>Bearing knowledge>What to pay attention to when using Lama to remove bearings

/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";

Matters to be taken when using the puller to remove the bearing

Source: China Bearing Network Time: 2013-08-29

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

1. When pulling out the bearing; be sure to pull the immediate screw and the middle of the shaft together; do not hurt the thread, shaft diameter and shoulder on the shaft, etc.
2, when loading the horse, the top of the head puts the best copper ball; the initial pull is slow; don't overdo it; in the pull board, it should not happen.
3, pull the pull position of the puller to be correct; pull the grip should pull the inner ring straight; to prevent the pull and fall; use the wire to tie the tie rod together,
4. The spacing between the tie rods and the length of the tie rods should be flat; prevent deflection and uneven force.

Recommend to friends comments close window

Bearing related knowledge

Bearing steel quality requirements and shortcomings (1)
The use of partial pain to determine the Y-bearing polyurethane coating of the ring non-marking bearing rolling bearing experience determination method magnetic motor ball bearing layout characteristics

This article links to http://
Please indicate the bearing network http://

Previous:Classification and determination of shaft seals Next: INA high-speed fine-angle touch ball bearing device

Steel Elbow

Steel Elbow,Pipe Fitting Elbow,Stainless Steel Elbow,Carbon Steel Elbow

Cangzhou Youlong Pipe Fitting Manufacturing Co., LTD , https://www.ypco88.com