The price of tiles must be a major concern for many homeowners. The quality of ceramic tiles depends on their future maintenance and service life. If you do not lay it well, you will not only waste money but also waste manpower when it is repaired. Then, Xiaobian will introduce the price of tiling and the step of tiling.
First, the tile step
1, wall tiles should be laid from the bottom up, and a wall can not be posted to the top, the seam is generally 1 to 3 mm;
2. Before the pavement, firstly deal with the smoothness of the wall and handle the cracks;
3. The adhesive material must be applied to the middle slightly higher than the circumference, and the rubber hammer is used to strike the surface to fix it, so that air accumulation in the adhesive layer can be avoided. At the same time to carry out level testing;
4, Adhesive materials should be selected and appropriate, the ratio of cement and sand in the general wall surface is 1:4, and the ratio of cement and sand in the ground is 1:3.
Second, the method of tricks when tiling
1. Use the nylon thread to pull out the ground elevation line on the wall to do a good positioning effect. Then we will tile according to the position of the positioning line.
2. Lay the 1:2 cement mortar on the back of the tile, then lay the tile on the ground, and then use a rubber mallet to hit the surface of the tile so that the height of the paved tiles is the height of the ground we pulled. Anastomosis to ensure the uniformity of the tiles posted.
Third, pay attention to after the tile
After we stick the tile, we must wait for the tile to dry before we can apply gravity on it to prevent the tiles from being deformed. Also, check the tiles that have been laid, and tap the tiles gently to hear if there is an empty place. If there is an empty place, we must repair the tiles in time.
Fourth, tile prices
The price of tiling is generally calculated based on the number of square meters of our tile. For the price of tiles on the market, the price of laying a square tile is between 10 and 15 yuan.
Editing summary: The analysis of the tiling price and tiling step is introduced here. For more information, you can follow this site information.
Tile tile tile tile price tile adhesive
150W Quantum Board Samsung Lm301h
High power: high power can provide enough light intensity to enable plants to carry out photosynthesis and normal growth.
High efficiency: The use of LED lamp beads as a light source, with high light efficiency and low energy consumption characteristics, more energy saving than traditional fluorescent lamps and high-pressure sodium lamps.
Full spectrum: Plant lamps usually adopt full spectrum design, which can provide different wavelengths of light required by plants, including blue, red, ultraviolet, etc., to promote the growth and flowering of plants.
Adjust the brightness and spectrum: some advanced plant lamps also have the function of adjusting the brightness and spectrum, which can be adjusted according to different plant needs and growth stages.
Heat dissipation design: Due to the high heat generated by high-power LED lamp beads, plant lamps are usually equipped with heat dissipation devices to ensure long-term stable work of the lamps.
grow light spectrum led grow light indoor led grow
Shenzhen Pvison Technology Co., Ltd. , https://www.pvisunggrowlight.com