If you go back to Nantian, you may become very wet indoors. A lot of water can be wiped out on the wall. If the water vapor on the wall is not removed in time, it is prone to mold and so on. Let's take a look at how the wall is treated after it gets wet.
First, the painted wall surface is treated with moisture
1. Found that water vapor is cleared in time.
During the wet weather, open the window as little as possible. If you find that there is already condensation on the wall, you need to take timely measures. The moisture on the wall can be sucked up by means of a dehumidifier, an air conditioner and a fan. After the emergency treatment, you can keep the indoors dry by referring to the various methods mentioned on the previous page.
2, the wall surface is mildewed
If the wall surface has been moldy due to moisture when it is discovered, the following steps can be taken to remove the mold.
(1) Wipe the painted wall with mildew water, 84 disinfectant or bleaching solution (diluted to 5-10%), and wipe the mold spots quickly. The method is to use a rag to easily wring it out and wipe it or spray it with a small watering can.
(2) When indwelling for 24 hours, wipe it with water. Use a clean rag, rinse with water, and wipe. If the mold is serious, wipe a solution. In order to avoid mold again, care should be taken to completely dry the wall.
3, the wall is difficult to erase mold
If the wall paint film is soy moldy and cannot be completely wiped clean, the area is large and conspicuous, then the primer and topcoat need to be re-applied. When purchasing paint, pay attention to the purchase of products with good mildew resistance.
Second, the wallpaper wall is treated with moisture
Back to the South, indoor air vapor is too much, coupled with poor indoor ventilation, it is not uncommon to produce mold on the wall with wallpaper. The mold treatment of the wallpaper wall is similar to the painting of the wall surface: the water vapor is found to be wiped out in time; a small range of mold is found, and the solution is wiped off with a solution such as mildew water; and if it is a wide range of mold and difficult to erase, it is recommended to replace the wall as a whole. Face wallpaper.
[Follow the WeChat public number "Jiuzheng Paint Network"; pay attention to surprises, scan code to view "If your husband is selling paint..." Jiuzheng Coating Network Exchange Group]
Accelerometer Sensor are widely used to monitor vibration in aerospace, automotive and manufacturing applications. Mechanical engineers often use them to diagnose problems with rotating equipment or assess the stability of structures that are subject to periodic stresses (such as monitoring the vibrations caused by trains/trucks crossing bridges, etc.) They are also often used in monitoring for condition-based maintenance, allowing engineers to examine the vibrations produced by a piece of equipment to assess its health, and monitoring the stresses sensitive equipment undergoes during transportation.
The most common method of acquiring vibration data involves connecting Accelerometer vibration sensor and configuring them into a data acquisition system that can deliver high-resolution (24-bit) vibration data at very high sample rates. Modern data acquisition systems can plot, log, filter, and analyze vibration data in real time, and allow using a variety of accelerometer types.
Accelerometer Sensor, Accelerometer vibration sensor, Acceleration sensor, MEMS vibration sensor,Triaxial Accelerometer Sensor, Triaxial Accelerometer
Xi'an Gavin Electronic Technology Co., Ltd , https://www.cngamicos.com