As a new type of home-improvement building material, glass solid wood doors are not only fashionable, but also widely used, so they are deeply loved by small partners. What are the methods for installing glass solid wood doors? At the same time, what are the precautions for the installation of glass solid wood doors ? Let Xiaobian take everyone to understand the methods and precautions for installing glass solid wood doors .
First, glass solid wood door installation method:
1, positioning, put line
According to the requirements of the planning and design drawings, the positioning line of the glass solid wood door is determined, and the door frame position must be clearly defined. In the gaps at the top of the top and bottom brackets, and at the gaps between the thick glass and the frame column, inject the glass seal and use a tool to scrape the excess glass glue.
2, the installation box top limit slot
The width of the limiting slot is two to four millimeters greater than the thickness of the glass and the depth of the slot is ten to twenty millimeters. During assembly, the two metal decorative board edges are initially drawn from the midline of the bullet, and then the limiting groove at the top of the door frame is pressed along the edge to adjust the groove depth in the notch through the glued mat.
3, the installation of metal veneer wooden tray
The square wood is fixed on the floor and the metal veneer is fixed on the wood with adhesive. If aluminum alloy square tubes are used, they can be fixed on the frame columns with aluminum corners or with wood screws on wooden bricks embedded in the ground.
4, install the vertical door frame
Using plywood to clear the appearance and position of the wooden door cover, you can package the metal decorative surface. When decorating the bag, it is necessary to place the head facing seams on the two sides of the device glass in the middle door.
5, install the glass
First move the thick glass plate to the place where it needs to be installed. Then insert the top of the glass into the limit slot at the top of the door frame and place the bottom of the glass on the bottom bracket. Two small wooden sticks on the inside and outside of the bottom bracket are used to sandwich the thick glass in the middle door. The square sticks are coated with all-purpose adhesive and the decorative metal is glued to the square wood strips.
Second, glass solid wood door installation notes:
1. Before the installation, it is necessary to check if the door and window fan is flat and whether the hole has been reserved completely and correctly. If it meets the requirements, it should be corrected first. The installation of steel frames and door leaf glass shall be fixed with wire cards. The spacing shall not be greater than 300mm and not less than two on each side. It may also be used to wipe the putty finish on the steel wire cards to increase the sealing performance.
The above is all about the glass solid wood door installation method and the glass solid wood door installation precautions, and I hope to help everyone. If you want to know more relevant knowledge, you can continue to pay attention to the relevant information of this website. Xiao Bian will bring more exciting content for everyone.
Street Light,Smart Street Light,Outdoor Street Light,Garden Street Light
Guangdong Smart Street Lighting Co., Ltd , https://www.gdfldlight.com