The installation of electric water heaters must use the special hooks and expansion tubes or expansion bolts. The sockets that are horizontal, firm and beautiful, and must be grounded to the electric water heater must be grounded. The sockets and electric water heater plugs should be matched. During the test, the air in the water heater's bladder should be excluded, and the water can be started after being filled with water.
1 Install the water circuit first, then install the circuit. Waterway installation. First fix the hook to the wall with a special screw, hang the water heater, and then install the mixing valve on the tap water pipe with the valve. The mixing valve and the water heater are connected by the inlet and outlet pipes, nuts and sealing rings.
2 Clean the system. After the waterway is installed, first clean the entire system and install the circuit. The specific method is: close the cold water valve, open the hot water valve, open the tap water valve, and let the cold water be injected into the water tank. When the mixing valve has water flowing out, the flow can be increased, the water tank pipeline is flushed, the cold water valve is opened, and the valve body is flushed. The internal passage is then connected to the shower head.
3 circuit installation. Install the power switch at a distance of 1 meter from the water heater and 1.5 meters above the ground. Open the water heater casing and connect the power cord. Be careful to select the appropriate power cord according to the power and connect the ground wire.
Wall-Mounted Led Pool Light,Waterproof Pond Led Light,Surface Mouted Pool Light,Stainless Steel Pool Light
Guangzhou Qshine Pool Lights Manufacture Co., Ltd , https://www.qshinepoollight.com