Normally, the renovation of home improvement hydropower is a construction project with a "head start" for the construction party. It seems that the quotation is not expensive, but it usually takes several thousand yuan or even more than ten thousand yuan to complete. For the decoration owner, the hydropower transformation is the most important part. You ca n’t ignore the construction quality because of the excessive cost savings, so that the other party "has not taken the lead", such as purchasing inferior and cheap materials, non-standard construction, and poor design considerations. , Thereby affecting normal life.
Only choose low-cost hydropower materials
Assuming that the owner only pays attention to the price and ignores the quality of its materials, after the project is completed, if there is a problem with the water pipe or wire, it is very troublesome to open the wall to repair, and the quality of the water pipe and wire is easy to cause a safety accident.
Mr. Cao, a project manager who has been engaged in construction management for many years, said that some owners often pay less attention to quality when purchasing water pipes and wires to save budget, but only value the price. This is a major mistake. If the quality of the wires and pipes does not meet the standards, after renovation Will bring great security risks. Mr. Cao said that if it is necessary to control the budget, the standards of some other materials can be appropriately lowered. Hydroelectric materials cannot be lowered. High-quality products should be purchased as much as possible to ensure safety.
Too few electrical outlets installed
During the renovation of water and electricity, many owners thought that the installation of one plug would save some wires, so they reduced the number of power outlets as much as possible. However, there are more and more general household appliances. Once you have new appliances but no sockets, it is difficult to install them again.
"If there are wiring boards everywhere in the later stage, there are also hidden safety hazards, and it affects the appearance of the room, and it is not convenient to use." Designer Ms. Chen said that the wiring board can only be used as a temporary convenience, the key is to consider comprehensive when routing, if There are few sockets, you can only add a wiring board, and then use several pieces of equipment together, which is easy to cause accidents. Therefore, according to the house size and area, according to the design of a professional electrician, the actual number of household electrical appliances should be integrated, the power plug should be reasonably placed, and some unused sockets should be left to facilitate expansion.
Irregular laying of water pipes and wires
"The trend of the water pipes is irregular, the water pipes are bent, and the water pipes are all underground. This is a common mistake in water pipe construction." Master Liu, a hydropower project manager of a certain decoration company, said that some owners think that the water pipe connection does not need to be too particular, but connect at will The water pipe will increase the probability of water leakage of the water pipe, which is even more unfavorable for future maintenance. When you are supervising the work, you must urge the decorator to strictly follow the construction specifications. The direction of the water pipe must be certain, and the direction is generally parallel to the wall. Try to avoid the water pipe from forming a certain angle with the wall; in addition, the direction of the water pipe should be avoided. Open the wire tube to avoid touching the circuit when water leakage occurs, causing danger; when laying the waterway, the water pipes must be connected by joints, the general elbows are at 90 degrees; the waterway can be placed on the ceiling of the ceiling in addition to walking on the ground Inside, convenient for maintenance.
"The circuit transformation should be carried out strictly." Master Liu said that in the circuit transformation, strong and weak electric common pipes, repeated wiring, direct buried wires without bushings, and random installation of socket wires are four common mistakes, and these mistakes are not only easy The circuit is prone to use failure, and it may also cause hidden dangers of electric shock and fire accidents.
It is difficult to maintain in the future without leaving the pipeline diagram
In fact, many decoration owners know that decoration is a process of continuous improvement. Sometimes, after a few years, the decoration or repair may need to be carried out again. At this time, it is necessary to have a layout plan for the laying of electrical wires and water pipes. Otherwise, like installing air conditioners in the later stage, if you need to make holes in the air conditioner, if there is no wiring diagram, you may hurt the wires and water pipes.
The decoration designer Mr. Ma reminded that the decoration owner should pay attention to that after the hydropower transformation is completed, the hydropower construction party is required to give a detailed and standardized hydropower transformation plan, indicating the location of important nodes, for future reference. Of course, during the construction process, the owner's "taking pictures" at the construction site is also an effective aid.
* Plate FLANGE (Plate Flange, Flat Flange, Plain Flange)
* SLIP ON FLANGE (SORF SOFF FLANGE)
* WELDING NECK FLANGE (WNRF FLANGE)
* BLANK FLANGE (BLIND FLANGE, BLFF FLANGE, BLRF FLANGE)
* THREADED FLANGE (SCREWED FLANGE)
*BACKING RING FLANGE
Blank Flanges,BS4504 Blank Flange,DIN 2527 Blank Flanges,Steel Blank Flanges
Shandong Zhongnuo Heavy Industry Co.,Ltd. , https://www.zhongnuoflanges.com